|
The Techne Range of Conductivity Meters
|
TechneŽ offers a wide range of Conductivity Meters available as either
portable or laboratory instruments. A brief summary of the Conductivity
Meters available is outlined below, and further details can be found by
following the link to the instruments individual page |
|
|
Model 470 is a general purpose, hand held Conductivity and TDS meter offering direct calibration on standard solutions or by direct cell constant entry. The backlit LCD simultaneously shows temperature compensated conductivity or TDS and temperature. The conductivity/TDS rang is automatically selected for optimum resolution and temperature compensated using an adjustable coefficient. |
|
| The Model 4150 Conductivity Meter is available from of our Premier Portable range. Supplied with a robust epoxy sensor, it has a reference temperature selectable between 18, 20 or 25ēC. The temperature coefficient can be digitally set to any value between 0 and 4.00%/ēC, with a default to 2.00%/ēC - a value acceptable to many analytical situations. This instrument can also measure Total Dissolved Solids using an in-built conversion factor. |
 |
| The Model 4200 Premier Portable Conductivity Meter measures between 0 and 199.9mS, covered by five automatically switched ranges using a single cell. In-built software is able to calculate and report results as Total Dissolved Solids in mg/l, Salinity in g/l or Resistivity in MOhms. A "pure water" mode enacts the non-linear temperature coefficient characteristics associated with low conductivity water. |
 |
| The Model 4510 Laboratory Conductivity Meter is designed for routine analytical laboratory situations. Simultaneous display of conductivity and temperature are available on the custom segmented display. Calibration and result verification is possible by reference to standard calibration values. |
 |
| The Model 4520 Laboratory Conductivity Meter features a full 114 x 128 graphics LCD. Conductivity values can be displayed in a selection of units suitable for the particular sample under test; Siemens for routine requirements, MOhms for samples with low conductivity (such as purified water) and Total Dissolved Solids relating conductivity to the concentration of NaCl. A salinity mode displays conductivity results in ppm NaCl. The DataWay PC software can be used for data acquisition. |
 |
| The NEW Model 3540 is a combined Conductivity / pH Meter. It is ideal for use in water testing applications and in all laboratories where pH and conductivity analysis is required. It offers a space saving and flexible approach to the measurement of these two parameters. The DataWay PC software can be used for data acquisition. |
 |
In addition to the above, a comprehensive range of accessories and probes are also available.
